Western Digital OpenFlex Data24 EcoDesign Manual page 32

EcoDesign Disclosures
Table 2: Replacement Procedure Info
• T7 Torx screwdriver
• T10 Torx screwdriver
• 4.5mm nut driver
• Tweezers or needle-nose pliers
(recommended)
Step 1 : Using a T7 Torx screwdriver, remove the eight (8) screws securing the IO Module (IOM) cannister
cover:
Figure 50: IO Module (IOM) Cannister Cover Screw Locations
Step 2 : Slide the cover toward the rear of the IO Module (IOM) to remove it:
Required Tools
1. EU EcoDesign Disclosures
1.5 IO Module (IOM) Disassembly
# of People Required
• 1
28