Western Digital OpenFlex Data24 EcoDesign Manual page 30

EcoDesign Disclosures
Figure 46: Midplane PCB Screw Locations
b. Lift the rear edge of the midplane PCB, and pull it toward the rear of the Chassis. This will
free the drive connectors from their holes in the mid-chassis support.
Figure 47: Freeing the Drive Connectors
c. Lift the front edge of the midplane PCB until it is sitting at an upward angle. Then remove
the midplane PCB. The LED cables should slide easily out from the locations where they are
threaded into the Chassis.
1. EU EcoDesign Disclosures
1.4 Chassis Disassembly
26