Western Digital OpenFlex Data24 EcoDesign Manual page 19

EcoDesign Disclosures
Figure 24: Top Cover Assembly Removal
Step 12 : Remove the rear system LED PCBA.
a. The rear system LED PCBA is located behind an access panel on the center divider of the
IO Module (IOM) compartment. Using a T7 Torx screwdriver, remove the three (3) screws
holding the panel to the Chassis:
Figure 25: Rear LED Access Panel Screw Locations
b. Pull the bottom of the panel outward, and then pull the panel down to remove it from the
Chassis:
1. EU EcoDesign Disclosures
1.4 Chassis Disassembly
15