Western Digital OpenFlex Data24 EcoDesign Manual page 26

EcoDesign Disclosures
Figure 38: PDB-A Screw Locations
c. Carefully pull PDB-A upward to separate it from its connector on the midplane and remove it
from the Chassis:
Figure 39: PDB-A Removal
Step 17 : Remove the bottom drive guide plate.
a. Using a T7 Torx screwdriver, remove the eighteen (18) screws holding the bottom drive
guide plate to the Chassis. There are 9 screws inside each drive bay, and their locations
mirror each other. The left-side screws are shown in the following image:
Caution: To prevent damage to the PDB leads and midplane connector, do
not twist or torque the PDB when removing it from the midplane.
1. EU EcoDesign Disclosures
1.4 Chassis Disassembly
22