Change Timers; Commonly Used Timers; Occupancy Timer And Suspend - Pyronix ENFORCER V11 Programming Manual

Set point in
Enter the areas that the arming station is located in.
Set point description
Enter a name and location for the arming station.

CHANGE TIMERS

CHANGE TIMERS?
This function controls all timers on the system.

COMMONLY USED TIMERS

For a list of all timers, see
Entry Time (0-255 seconds)
Confirm Time (1-99 minutes)
Please note: The timer for zones on 'Soak Control' is in the function 'ENGINEER TESTS' .

OCCUPANCY TIMER AND SUSPEND

This timer and the suspend option both work in conjunction with the zone occupancy attribute and the
programmable occupancy actions when/if the time expires without activation.
Occupancy timer
This timer (set in hours) defines the period of time that any zones with the occupancy attribute enabled must be
trigger in.
Occupancy suspend
Defines the areas which will suspend the timer if armed.
Example
Zone 1 has the occupancy attribute enabled and is located in area A.
•
• The occupancy timer is set to 1 hour and occupancy suspend option reads '[A ]' on the screen.
EVENT
The system is completely disarmed and zone 1 has
not been triggered for 1 hour.
The system is completely disarmed and zone 1 is
triggered before 1 hour expires.
Area A is armed and the zone has not been
triggered for over an hour.
For occupancy attribute information, see
To program the actions when the timer expires, see
24
"Appendix C - Timers" on page
Exit Time (0-255 seconds)
Wireless Supervision (0-99 hrs)
"Input Attributes" on page
"Occupancy Zones" on page 29.
ENFORCER V11 PROGRAMMING GUIDE
52. Most common programmed timers are:
RESULT
The pre-programmed action is taken.
(External alarm, SMS, keypad etc.)
The 1 hour timer is reset and the zone must be triggered
again within the next hour to prevent action being
taken.
No action. The 1 hour timer will commence when the
system is disarmed.
17.
Siren Time (2-15 minutes)
App Exit Time (0-199 seconds)