Pyronix ENFORCER V11 Programming Manual page 55

NO. TYPE
0030 Confirmed Hold Up Any
0033 Entry/Exit
0034 Lights
0035 Follow Input
0037 Restore 1
0038 Restore 2
0039 PIR Latch 1
0040 PIR Latch 2
0041 Mains Good
0042 Detr Indn Enable
0043 Follow Test
0044 Off During Test
0048 Detr Walk Test
0049 Detector Masked
(Not applicable on
grade 2 systems)"
0050 Follow 24 Hour
0051 Line Fault
0052 Mains Fail
0053 Battery Faults
0054 Low Volts
0055 "Global Fault 1
(Faults: Modem, Battery,
Fuse, Line, Mains)"
0056 "Global Fault 2
(Faults: as above)"
0058 Guard Code Used
0059 Engineer Access
0060 Initialise Digi
0063 Test ATE/GSM
ACTIVE
When more than one confirmed
hold up activates
Live during any entry or exit time
When exit or entry timer starts
When input triggers
At code entry to set
At code entry to set
When set (and in Walk Test)
This is the inverse polarity to PIR Latch 1
Output showing the mains is healthy
This output activates during walk test and also when a code is entered to
view indications – staying activated for the time for which the indications
are viewed.
New output for alternative bell test by activating SAB
New output for alternative bell test by activating SAB
This output is active during walk test, and will only deactivate when all
detectors have been tested.
If any detector goes into 'mask'
condition the output will trigger
If any input programmed as "Day
alarm" activates
When Line Fault signalled by
communicator
After pre-set time without mains
power
When battery disconnected or load
fail detected
When the input voltage from the
transformer is too low
At fault
Activates if fault occurs only when
system is armed
When 'guard' code accepted
When entering Engineer Mode
At power up
Test signalling through PSTN and
GSM. Activates when a test call is
sent.(Only used for specific GSMs)
ENFORCER V11 PROGRAMMING GUIDE
RESTORE
At next code entry
20 seconds after set/disarmed
procedure completed
Dependent upon programming
After 3 seconds
When disarmed
At alarm, or when disarmed
When masking fault clears.
When input restored
When fault clears
On restoration of mains
At next valid code entry
When the control panel reads the
correct voltage.
When fault clears
When all faults cleared
After 60 seconds
Leaving Engineer Mode
Live for 45 seconds only
When test completed
55