Control Inputs; Learn Devices; Delete Devices; Control Bells - Pyronix ENFORCER V11 Programming Manual

CONTROL INPUTS?

Learn devices?

This menu starts the procedure of learning wireless zones onto the system.
Input
This menu chooses which zone on the system is to be learned. 'Learnt' will be displayed if a device is already
learnt, or 'Available' if it is not.
Learning...
Open the wireless device.
Remove the plastic insulation to enable the battery.
If the device is not learnt, the GREEN and RED LEDs on the device will flash (alternating).
Press and hold the 'learn' button on the device and all three LEDs start cycling BLUE, GREEN and RED.
Release the 'learn' button. If successful, 'Input Learnt' will be displayed on the keypad and a confirmation tone will
be emitted.
If that zone has already been learnt, 'Input learnt already' will be displayed.
To locate the learn button on each wireless peripheral, please refer to the installation guide provided with the
device.

Delete devices?

Already learnt zones may be deleted from this menu.
Delete all
To delete all wireless zone devices, enter '2000' . 'Please wait' will be displayed while the system deletes all the learnt
wireless zones.
Choose input to delete
This option deletes only a specific wireless device learnt to a zone. Any zones that display 'learnt' can be deleted.
'Please wait' will be displayed while the panel deletes the wireless device. Return to this process to delete more
devices.

Control bells?

Learn devices?
Entering this menu allows the learning of wireless bells onto the system.
Select bell
Selects the bell on the system that is to be learnt. 'Learnt' will be displayed if a bell is already learnt, or 'Available'
will be displayed if not.
Learning...
Open the wireless bell.
Plug the battery connector into the battery terminal.
If a device is not learned, the GREEN and RED LEDs on the device will flash (alternating).
Press and hold the 'Learn' button on the device and all three LEDs start cycling BLUE, GREEN and RED.
Release the 'Learn' button. If successful, 'Bell Learnt' will be displayed and a confirmation tone on the panel will be
emitted.
If a siren has already been learnt, 'Bell learnt already' will be displayed.
13
ENFORCER V11 PROGRAMMING GUIDE