Pyronix ENFORCER V11 Programming Manual page 39

Example 1
The below sequence shows what happens when the attributes are programmed as 'Starts at Keypads [0]' and
'Stops at Digi [3]'
When the event is
triggered, only the
keypads are audible.
Example 2
The below sequence shows what happens when the attribute are programmed as 'Starts at Bells Only [2]' and
'Stops at Digi [3]'
When the event is
triggered, the keypads,
internal sounders and
external bells are all
audible simultaneously.
Please note: Any signalling will depend on programming in other menus regarding externals
communications. See Communications Guide for more information.
15 seconds later, the
internal sounders
become active.
15 seconds after the
activation, the system
signals the event.
ENFORCER V11 PROGRAMMING GUIDE
After 30 seconds from the
initial event, the external
bells trigger.
45 seconds after the
sequence began, the
panel will signal the
event.
39