Table of Contents
Advertisement
NSB-7
Service Software Instructions
Service Software
General
To run the Service Software, a parallel port software protection device (PKD-1) has to be
connected. TDF-4 box must connected to PC for flashing purposes. The test functions
send test messages from PC to mobile stations (MS) and receive results and show them
in the PC display. The messages can be sent via M2BUS or FBUS.
Note: if this software is to be run on lap top's, the power saving feature MUST be
switched off.
Hardware requirements for Windows 3.11
The recommended minimum hardware standard to run Service Software is any computer
which is 386 33 MHz or greater with at least 4 MB of memory and VGA type display (640
x 480). This assumes that only the WinTesla with phone module is active, i.e. other Win-
dows packages are not running in the background.
Hardware requirements for Windows 95
The recommended minimum hardware standard to run Service Software is any computer
which has Pentium processor, memory 8 MB and meets HW requirements recommended
by Microsoft.
Software Environment of the Support Modules
The Service Software user interface is intended for the following environments: Micro-
soft Windows 3.11, 95 and NT. For those who are familiar with Windows environment
this application will be easy to use. Detailed information about Windows and application
usage can be found from the relevant Microsoft Windows Users Guide.
As an ordinary Windows application, the main idea in the user interface is that selections
are made with menus, push buttons and short-cut keys. Selections can be done by using
keyboard and/or mouse. There is always a status bar displayed at the bottom of the main
window which contains information about current actions.
Page 6
ãNokia Mobile Phones Ltd.
PAMS Technical Documentation
Issue 1 06/00
Advertisement
Chapters
Table of Contents
Troubleshooting
