Installation; Mechanical Connections - Nokia NSB-7 Series Service Manual

NSB-7
Service Software Instructions
D15-D15 Cable AX5
DC Cable PCC-1
Software Protection Key PKD-1
IR module for TDF-4
*) Note:
ductor, or United Microelectronics IC 8250 as the serial port UART. This is a compara-
tively inefficient circuit for current purposes and does not necessarily support the
M2BUS adapter at 9600 baud. The newer UART's NS16450 and NS16550AF of National
Semiconductor offer solutions for these problems.

Installation

Mechanical Connections

Caution:
ing connections.
Caution:
PKD-1!
The software controls the phone via a separate adapter connected to the serial port of
the PC, and to the telephone's M2BUS (DAU-9S).
Attach the dongle PKD-1 to the parallel port 1 (25-pin female D-connector) of the PC.
When connecting PKD-1 to the parallel port, be sure that you insert the computer side of
the PKD-1 to the PC (male side). If you use a printer on parallel port 1, install the PKD-1
between the PC and your printer cable.
The PKD-1 should not affect devices working with it. If some errors occur (errors in print-
ing are possible) please try printing without the PKD-1. If printing is OK without the
PKD-1 please contact your dealer. We will offer you a new PKD-1 in exchange for your
old one.
Page 8
A number of PC's of an older generation use the Intel, National Semicon-
Make sure that you have switched off the PC and the printer before mak-
Do not connect the PKD-1 key to the serial port. You may damage your
ãNokia Mobile Phones Ltd.
PAMS Technical Documentation
0081275
0730053
0750018
0750079
Issue 1 06/00