Nokia NSB-7 Series Service Manual page 145

PAMS Technical Documentation
automatically when the dialog is opened. The test value is not saved to the EEPROM.
The test value can be changed during tuning as other power coefficients and the
program remembers its value when tuning function is activated later again.
If there is more power levels in the phone that can fit into window the window is
scrollable. When phone is initialised the program asks the number of power levels
used in the phone.
Only three power coefficients (highest, third smallest and lowest) are needed to tune
(left justified Coefficients) and the rest of them are calculated.
The tuning position is highlighted and can be tuned with +/- keys or left/right cursor
keys.
Calculate button (ALT+C):
The calculation is activated with this button. The power coefficients which are
calculated from the tuned coefficients are displayed on the different columns than
the others. All values can be tuned if needed. When Base level calculation is checked,
base level is calculated.
Base level calculation check box:
If this box is checked the base level is calculated.
Base offset edit box:
This edit box shows the base offset value that user can change. The base level
calculation check box must be checked before this value is used. After this value is
changed user must do the calculation. NOTE: Do not use Enter-button to accept this
value.
+/- buttons (+/- and left/right cursor keys):
+ and - buttons will cause power changing by 0.25dB steps. When these keys are used
the coefficient value is updated on the tuning window.
Save button (ENTER):
Dialog is closed and tuned values are saved to phone. Base offset is saved to
TESLA.INI.
Cancel button (ESC):
Dialog is closed and tuning is not saved to phone.
When selections are used, the power value checking is made and if it is not successful,
error message is shown. The test checks that all power coefficients are in descending
Issue 1 06/00 ãNokia Mobile Phones Ltd.
Service Software Instructions
NSB-7
Page 39