Custom Dialog Boxes; Buttons - Nokia NSB-7 Series Service Manual

Transceivers
Table of Contents

Advertisement

PAMS Technical Documentation

Custom Dialog boxes

All custom dialog boxes will contain the pre-defined buttons as defined below in the
section - Buttons. However, it is recognized that features may require additional button
types, but the addition of these non-standard buttons should be carefully considered to
minimise any inconsistencies between implementations.
The buttons will be positioned down the right-hand side of the dialog boxes. The default
action will be OK, except where that default action could result in an irretrievable fail-
ure.
All tuning dialogs that contain tuning results, will display the old tuned data read from
the phone before the tuning was performed, as well as the newly tuned data.
List boxes will be used to display lists of data, such as tuning data, test results etc.
The use of Radio buttons should be limited and carefully considered. The use of radio
buttons defines the number of possible choices available to the user, which may be
acceptable for one project, but not for another.

Buttons

All buttons must be the Microsoft style of buttons.
In general, the default button will be the action button, the Close button or the Yes but-
ton, but this will depend on the context of the dialog box that the button is associated
with.
(action) button:
Accepts and validates entered settings and values and closes the dialog. If the values
have not been changed, then no action will be taken. The status bar will reflect the
status. The user should only be queried, if the settings or values accepted will
over-write data that CAN NOT be reproduced.
A greyed OK button indicates that settings selected by the user are not acceptable.
Close button:
Closes the current dialog box. Does not send or store anything and closes the dialog.
The Close button is only used for dialogs that do not set or change any data.
Cancel button (Esc):
Cancel operation. Does not send or store anything and closes the dialog box.
A greyed Cancel button indicates that it is not possible to quit from this dialog box.
Issue 1 06/00
ãNokia Mobile Phones Ltd.
Service Software Instructions
NSB-7
Page 25

Advertisement

Table of Contents
loading

Table of Contents