Nokia NSB-7 Series Service Manual page 194

NSB-7
Service Software Instructions
If settings are not loaded back to phone after flashing those files are left and found by
application when phone is flashed next time. After successful loading to phone files
are removed.
Close button (ESC):
Closes the dialog box and does not start flashing.
Erasure Options group:
Erase Defined Area check box:
If it is checked, prommer erases from phone EEPROM area defined with Low limit and
High limit fields. If it is not checked only new blocks are erased from phone EEPROM.
If values in fields are not valid, then check box is disabled. Check box state is read
from flash pack ini-file, from entry EraseDefinedArea.
Low limit edit box (read only):
Hexadecimal value defining low erase limit, value should be plain hexadecimal
without any prefix. Field value is read from flash pack ini-file, from entry
LowEraseLimit.
High limit edit box (read only):
Hexadecimal value defining high erase limit, value should be plain hexadecimal
without any prefix. Field value is read from flash pack ini-file, from entry
HighEraseLimit.
Force Download check box (ALT+D):
Forces downloading of selected PPM file to a prommer even, if it already exists there.
Can be used to replace a corrupted file in a prommer with a proper one.
ROM Version Group:
ROM Version edit box:
Shows rom version of flashed phone.
Check button (Alt+A):
Checks connected phone, reads MCU SW and ROM version from the phone and loads
market areas. If application cannot detect ROM version, user is shown ROM Version
selection dialog. If application cannot detect phone type, user is shown Phone Type
Selection dialog.
LPT Port list box (ALT+L):
Page 88 ãNokia Mobile Phones Ltd.
PAMS Technical Documentation
Issue 1 06/00