Nokia NSB-7 Series Service Manual page 159

PAMS Technical Documentation
• Failed
• No response
• Not executed
• Not valid
• RUNNING....
Note that power-off test have no values, because if test has been passed, power has
been turned off. If power-off test fails a special error message window is shown. If no
response is received to power off test message in a few seconds, the user is informed by
special info window, where user is asked to turn the power on and then press the return
key.
Note also that power-off test (if passed) turns power off and power should be recon-
nected by using the phones key pad after the successful test. After the power has been
connected to phone, the normal start-up routines are made and the self-test results are
shown in the MCU self-tests menu (i.e. all other than power-up self-tests are in Not exe-
cuted state after the power-up routines).
Run button (ALT+R):
User can select desired test from list and hit Run button. When user selects test to be
run the text RUNNING... is shown in test state field and test is run. When results are
received the test state field is updated according to the result.
If no response was received in the defined time, an error message box will be shown
and the test state is changed to No response. Phone is set to local mode if it is not
already.
Run All button (ALT+A):
User can run all listed tests. The text RUNNING... is shown in test state field and test
is run. When results are received the test state field is updated according to the
result. When state field is updated application moves to next test and repeats
previous cycle. Phone is set to local mode if it is not already there.
Supported Self Tests
1 MCU ROM Checksum................
2 MCU RAM Interface...............
3 MCU RAM Component...............
4 MCU EEPROM Interface............
Issue 1 06/00 ãNokia Mobile Phones Ltd.
Service Software Instructions
NSB-7
Page 53