Pulse-Coherent Processing - Xylem SonTek FlowTracker2 User Manual

13.4. Pulse-Coherent Processing

This section does not attempt to provide a detailed description of pulse-coherent
processing. It presents a simple overview with a focus on how this affects
FlowTracker2 operation. SonTek can provide additional information on request.
The description of FlowTracker2 operation given in
an oversimplification.
•
Bistatic Doppler Current Meters
which the transducer sends a single pulse of sound and measures the frequency
change of the return signal.
• The FlowTracker2 uses a technique called pulse-coherent processing.
Pulse-coherent processing provides the best possible performance of any Doppler
processing technique. In the simplest terms, pulse-coherent processing works as
follows.
a) The FlowTracker2 sends two pulses of sound separated by a time lag (τ).
b) Each receiver measures the phase (φ) of the return signal from each pulse.
c) The change in phase (φ2 - φ1) divided by the time lag (τ) is proportional to
velocity.
d) Because of the nature of the phase measurement (which can only be determined
from -180° to +180°), the system has an inherent maximum velocity limitation.
e) The FlowTracker2 velocity algorithms have been optimized to give the best
possible performance over a wide velocity range of ±4.0 m/s (±13 ft/s).
f) FlowTracker2 processing provides unmatched results for low flows (<1 cm/s;
<0.03 ft/s).
FlowTracker2 processing has been designed to give the best possible performance in
all environments. However, there is a situation where system performance may be
affected by operating conditions.
FlowTracker2 User's Manual (January 2019)
Center of
Receiver Axis
Time after transmit pulse
Figure 13:2 - Signal to Noise Ratio Profile
describes incoherent Doppler processing in
SonTek – a Xylem brand
Ambient
Noise Level
Bistatic Doppler Current Meters is
227