Table of Contents
Advertisement
information is recorded in each measurement file and used in both the
Folder Naming
conventions.
• Existing templates created under "Device Configuration", parameters will be
prepopulated from
• Templates based on SonTek default configuration will have no information
populated and the user will need to enter the required details for each parameter.
It is not good data management practice for both measurement site references to be
empty or with abbreviate terms. It is recommended that the user makes use of
accurate site descriptions.
The New Data File screen consists of the following
parameters,
a) Site Number,
b) Site Name,
c) Operator,
d) Comment.
e) To select a parameter,
i). Use up or down scroll arrows keys to select a
parameter.
f) To accept the new data file configuration,
i). Press the Right Soft Key,
ii). The software will navigate to Automated Beam
Check screen.
g) To
CANCEL
new data file configuration,
i). Press the Left Soft Key,
ii). The software will return to New File Template.
9.2. Automated Beam Check
Duplicate of
6.4 Automated Beam Check
The Automated Beam Check function allows the user to perform a Beam Check in the
region of the measurement location before data collection starts. The automated beam
check performs a number of quality control checks on the data collected to determine if
the flow conditions are suitable for velocity measurements. The data displayed
graphically during the Automated BeamCheck is a time series of the Quality Control
parameters.
The Automated BeamCheck is an automated version of Beam Check function
described in
6.3 Beam Check.
Check was known as "Auto QC Test".
FlowTracker2 User's Manual (January 2019)
File Properties
information that was captured,
In the Original FlowTracker, the Automated Beam
156
SonTek – a Xylem brand
File Naming
Figure 9:4 - New Data File
and
Advertisement
Table of Contents
