Table of Contents
Advertisement
Step 1
PS Calibration screen allows the user to perform
pressure sensor calibration. The user is required to
remove the probe from the water.
a) To perform PS Calibration,
i). Press the Right Soft Key.
b) To
CANCEL
PS Calibration,
i). Press the Left Soft Key.
Step2
PS Calibration screen with Quality Control warning
messages based on quality control checks performed
on measurement data.
a) To accept quality control warning messages,
i). Press the Right Soft Key.
b) To
REDO
PS Calibration,
i). Press the Left Soft Key.
9.3.4.5
Complete Measurement
The Complete Measurement function closes the measurement file and the user will not
be able to add additional stations and or make any changes to the data captured. The
complete measurement function is a three-step process, firstly to determine if the user is
satisfied with the velocity measurements, secondly to perform quality control checks
against all measurement data and lastly to review measurement summary.
The Complete Measurement process allows the user to review the measurement data
before the complete function is selected at Summary screen. The user will not be able
to make any to changes to the measurement file from the handheld when this function
is selected.
Step 1
Confirmation screen of Complete Measurement
function confirms if the user wants to close the
measurement file. User will not be able to add
stations or make any changes to the data
a) To confirm complete measurement operation,
i). Press the Right Soft Key.
b) To
CANCEL
complete measurement operation,
i). Press the Left Soft Key.
FlowTracker2 User's Manual (January 2019)
Figure 8:29 – PS calibration
Figure 8:30 - Warning Messages
Figure 9:31 - Confirmation
175
SonTek – a Xylem brand
Advertisement
Table of Contents
