Table of Contents
Advertisement
11.3.4
O-rings
The FlowTracker2 handheld makes use of two O-ring seals and it is important that the
following guidelines are followed.
11.3.4.1
Housing
a) The handheld is designed to withstand temporary submersion, but is not intended
for underwater operation.
b) We do not recommend opening the handheld housing without specific instructions
from SonTek.
11.3.4.2
Battery Cap
a) The O-ring located on the battery cap prevents moisture entering the battery
compartment.
b) Inspection of the O-ring should be during
defects that may exist on the O-ring.
c) The batter cap, O-ring and battery compartment must be inspected for any
moisture, dirt or material that can damage the O-ring, battery or battery
connectors.
11.3.5
Condensation in FlowTracker2 Housing
Moisture in the air can potentially damage FlowTracker2 electronics if allowed to
condense inside the handheld housing.
a) The handheld is shipped with a desiccant pack inside to absorb moisture,
b) We do not recommend opening the handheld housing without specific instructions
from SonTek. If the housing has not been opened, the desiccant should not need
to be replaced.
11.3.6
Zinc Anodes for Corrosion Protection
When using the FlowTracker2 in salt water, additional precautions must be taken to
prevent corrosion.
a) A sacrificial zinc anode should be installed on the probe (attached to the metal
portion of the probe stem),
b) Anode condition should be inspected regularly, and the anode should be replaced
when necessary. Zinc anodes are available from SonTek,
c) To check anode condition, try to chip away part of the anode with a screwdriver. If
large portions of the anode easily fall away, the anode should be replaced,
d) The probe and cable should be thoroughly rinsed with fresh water after each use.
FlowTracker2 User's Manual (January 2019)
Hardware Inspection
189
SonTek – a Xylem brand
for any cracks or
Advertisement
Table of Contents
