Network Tool; Ip Address Scan; 2）Ping Test - Vitek VT-SCT-U4 Manual

Four inch hand-held 5-in-1 [4k h.265 ip / tvi / cvi / ahd / cvbs cctv] testing monitor

Table of Contents

VITEK 5-in-1 CCTV TESTING MONITOR

refer to "3.3.10 CVI camera test"

3.3.10 Network tool

Connect the cable to the LAN port, click icon

to enter, set your IP address search range by

changing the Start and End IP addresses. Click the "Start" button to scan the IP address range. You can

also input an IP address in the Port Number Scan to scan for open ports.

（（ 2）） PING Test

Connect a network cable to the LAN port and click the

icon to open the PING tool. You can set

your LOCAL (native) IP address, Remote IP address (e.g. IP camera), Packet count, Packet Size, Packet

time and Timeout. Press "Start" to start pinging. If the IP camera or network device is not configured

properly or not plugged in, it will say "Destination host unreachable" or have 100% packet loss. If the

tester connects to the device, the send and receive packets will have a 0% packet loss.

Page 39

Table of Contents