Analog Camera Connection; Hd Coaxial Camera Connection - Vitek VT-SCT-U4 Manual

Four inch hand-held 5-in-1 [4k h.265 ip / tvi / cvi / ahd / cvbs cctv] testing monitor

Table of Contents

VITEK 5-in-1 CCTV TESTING MONITOR

Note: If the IP camera requires PoE power, then connect the IP camera to the IP tester's LAN port. The

tester will supply PoE Power for the IP camera. Click on the icon labeled PoE to turn on/off PoE Power.

3.2.2 Analog camera connection

(1) Connect the camera's video output to the IP tester's VIDEO IN. The image will display on the tester

after pushing the PTZ icon

(2) Connect the camera or the speed dome RS485 controller cable to the tester RS485 interface (Note

positive and negative connection of the cable).

* CVI, TVI, AHD camera are classified as HD coaxial cameras. The following are instructions on how

to connect the TVI camera to the tester also apply to CVI, and AHD cameras.

Page 7

Table of Contents