Table of Contents
Advertisement
C. Baud
Move the yellow cursor to "Baud", Select the baud rate according to baud rate of the PTZ camera.
(150/300/600/1200/2400/4800/9600/19200/57600/115200)
D. Address
Set the ID according to the ID of PTZ camera (0~254), the setting address data must be consistent in the
speed dome address.
E. Pan speed: Set the pan speed of PTZ camera (0~63)
F. Tilt speed: Set the tilt speed of PTZ camera (0~63)
G. Set preset position (Set PS)
Click and select "Set PS", set and save preset position number (1~128),
H. Call the preset position (Go PS)
Click and select "Set PS", set and save preset position number (1~128), click "sure" to save,
Call some special preset number, can call the dome camera menu
Check and set the protocols, address, interface and baud -- all must be consistent with the dome
camera, then the IPC tester can test after setting the parameters. The tester can control the PTZ + lens.
To control PTZ by screen touch:
Tap left, right, upward and downward on the touch screen to control the PTZ rotation direction. With two
fingers move outward and inward on the touch screen to zoom in and out the PTZ.
PTZ Control:
2) Video and storage setting
Click icon "set" to enter and set analog video image brightness, contrast, color saturation, as well as the
file storage type after snapshot and recording (supports auto-storage and manual storage.)
When selecting manual storage, user can name and store the files.
VITEK 5-in-1 CCTV TESTING MONITOR
Page 26
Advertisement
Table of Contents
