6.3.7 Interfacing with a PEEK Instation
Scoot data optimisation should be disabled, see 'Optimise Data Transmission' in
section 6.6.6 OTU Advanced Config Screen
By default, the OTU configuration is set to run full UTC (UTC type 2). This section
describes typical sequence of operations to be carried out in order to switch from full
UTC to simple UTC (UTC type 1) operation. This may be required, for example, in order
to operate with an instation which has not yet been upgraded to support full UTC.
1. Go to the Status Config web page and select the NTP Screen
2. De-select 'Enable NTP'
3. Save the settings.
667/HB/31601/000
6.4 ACTIONS TO SWITCH TO SIMPLE UTC
Page 48
UTMC OTU/MOVA Handbook
Issue 5