The UTMC OTU/MOVA Outstation is a 3U rack mounted unit which is normally located
in roadside cabinets. The outstation is used to monitor and control a traffic controller
and other on-street equipment. – see UTMC Guide Appendix D.
The outstation is controlled from a UTMC instation across an IP network. The IP
network employed will be dependent on the system application and particular customer
requirements – see UTMC Network Requirements Appendix E.
Network to
Instation
IP
Network
Low voltage
Relay outputs
Low Voltage
Digital
Inputs
To Controller
serial port
Ethernet
Mains
supply
The UTMC OTU has the following features:-
667/HB/31601/000
2. PRODUCT DESCRIPTION
2.1 INTRODUCTION
UTMC
Outstation
Figure 2.1 – Typical Outstation
Expansion
Bus
PSU and BATTERY
Lease
Lease line
Line
Modem (optional)
Figure 2.2 – Hardware Components
Page 11
UTMC OTU/MOVA Handbook
On-Street
Equipment
Digital IO Port
Low voltage inputs.
I/O Card 3 (optional)
I/O Card 2 (optional)
I/O Card 1 (optional)
Processor Card /999 variant
Local PC/handset
Port
Issue 5