Siemens UTMC OTU Handbook page 70

ctlr.handset.in.1
cpu.out.1
busmova1.out.1
busmova2.out.1
busmova3.out.1
csi.control.out.1
csi.utc.to.out.1
csi.mova.to.out.1
csi.cond.out.1
The following are only available in MOVA 7 or later
mova1.alerts.in.1
mova2.alerts.in.1
mova3.alerts.in.1
mova4.alerts.in.1
Bit
Indicates the I/O bit number to be wired to the controller in the case of I/O Card,
or the serial message bit assigned in the case of the Controller Serial Interface.
Invert
This field indicates whether the signal should be inverted or not. Select the
checkbox to invert the signal.
The reply bits for a freestanding OTU should generally be inverted and all other
signals left in their normal sense.
DFM Act
Time in minutes that the detector may be Active before a Detector Fault is
asserted. Intended for use with detector inputs which are not already monitored
by the controller.
Valid timeouts range from 1 to 5460 minutes. A typical value is 30 minutes.
A value of zero disables DFM.
DFM Inact
Time in hours that the detector may be InActive before a Detector Fault is
asserted. Intended for use with detector inputs which are not already monitored
by the controller.
Valid timeouts range from 1 to 96 hours . A typical value is 18 hours.
A value of zero disables DFM.
Delete Row
667/HB/31601/000
Status of the controller handset link:-
Bit 1 is set to 1 while XXC command active (available on
both semi-integral and freestanding units with firmware
32370 issue 3 and above)
2 control outputs on CPU card
16 control outputs on I/O card 1
16 control outputs on I/O card 2
16 control outputs on I/O card 3
32 control outputs to controller serial interface
1 UTC Transmission Confirm output to controller serial
interface
4 MOVA Take Over outputs to controller serial interface, one
for each MOVA stream
16 conditioning outputs to controller serial interface
TMA alert input for stream 1
TMA alert input for stream 2
TMA alert input for stream 3
TMA alert input for stream 4
Page 70
UTMC OTU/MOVA Handbook
Issue 5