Setting Up The Windows Bluetooth Link (Ivt Blue Soliel / Widcomm); Setting Up The Windows Bluetooth Link (Advent Netbook) - Siemens UTMC OTU Handbook

C.3 Setting up the Windows Bluetooth Link (IVT Blue Soliel / Widcomm)
1. Plug in the USB Bluetooth dongle and start the IVT BlueSoleil software from the
start menu [Start
2. Perform a device discovery [Main menu
Discovery]
3. After a short pause icons should appear around the orange circle in the middle of
the screen. If no icons appear – and the status bar at the bottom of the window
reports "No new devices found" then an error has occurred.
4. There may be several icons in the centre of the blue screen; most likely mobile
phones and/or PDAs. Look for an icon that looks like a computer, right click on it and
select "Pair Device"
5. When prompted to enter a paring code – enter the number "1234" in to the dialogue
box and click OK; you will only have 30 seconds in which to do this. If the pairing
fails or no prompt is given during the pairing and there is more then one computer
like icon on the screen go back to step 4 and repeat on the other icon(s) as required.
6. A successful pairing is indicated by a small red tick next to the device icon in
question – the name of the device may also change from an ID (xx:xx:xx:xx:xx:xx) to
AirXL.
7. Once pairing with the adaptor is complete; right click its icon and select "Refresh
Services".
8. Wait for the status bar at the bottom of the window to read "Service Discovery
finished" and then right click on the adaptor icon again to start the Bluetooth serial
service [Right click device icon
9. If presented with a dialogue box, click "Yes" and make a note of the new COM port.
If no dialogue box is presented; the COM port information will be displayed in a
notification popup in the bottom right of the screen.
10. A successfully established connection is indicated in the BlueSoleil window by a
dotted line with a red circle running along it connecting the AirXL icon and the
orange circle in the middle of the screen; a signal strength indicator may be present
as well.
11. If the connection "Bluetooth link to Gemini" has already been set up then go to C.2
"Setting up the PPP over Bluetooth-serial connection" Step 9; otherwise go to C.2
"Setting up the PPP over Bluetooth-serial connection" Step 1.
C.4 Setting up the Windows Bluetooth Link (Advent Netbook)
1. Ensure that the Bluetooth radio is activated (indicated by blue indicator LED on the
bottom right hand side of the laptop). If it is not; press Fn – F11 until the Bluetooth
radio is online.
2. Open the Bluetooth settings manager [Start
3. Click the "New Connection" button and select "Custom mode" from the options in
the wizard, click "Next"
4. Select AIRserial3X from the list of discovered devices and click "Next". If the device
is not shown – ensure the adaptor is on and press refresh.
667/HB/31601/000
Progams IVT BlueSoleil
Connect
Page 121
UTMC OTU/MOVA Handbook
BlueSoleil]
My Bluetooth Bluetooth Device
Bluetooth serial]
Bluetooth Settings]
Issue 5