Siemens UTMC OTU Handbook page 2

In the interests of health and safety, when using or servicing this equipment, the
following instructions must be noted and adhered to:
(i) Only Skilled or Instructed personnel with relevant technical knowledge and
experience, who are also familiar with the safety procedures required when
dealing with modern electrical or electronic equipment, are to be allowed to use
and/or work on the equipment. All work shall be performed in accordance with
the Electricity at Work Regulations 1989 and the relevant Highways Agency
(DoT) procedures of test and maintenance.
(ii) Such personnel must take heed of all relevant notes, cautions and warnings in
this handbook, and any other documents and handbooks associated with the
equipment including, but not restricted to, the following:
(a) The equipment must be correctly connected to the specified incoming
power supply.
(b) The equipment must be disconnected / isolated from the incoming power
supply before removing protective covers or working on any part from
which protective covers have been removed.
(c) The equipment contains batteries that must be disposed of in a safe
manner. If in doubt of the correct procedure, refer to the Siemens
instructions.
667/HB/31601/000
SAFETY WARNINGS
Page 2
UTMC OTU/MOVA Handbook
Issue 5