9. Check the bearing.
The hub must turn smoothly.
The hub must not have axial play.
10. If necessary tap in the bearing on the non disc
side or loosen the bearing.
11. Repeat previous steps until the hub is turning
smoothly.
Putting on the End Caps
1. Grease the bearings and the inner surface of
both end caps (fig. 3-3/1).
2. Screw on both end caps (fig. 3-3/1) by hand.
3. Tighten the end cap (fig. 3-3/1) with 15 Nm using
a wrench.
20 mm, 15 mm und 9 mm end caps: 22 mm
open-end wrench
QR end caps: 5 mm Allen key
Closing Steps
Mount the brake disc.
Further information can be found in the Technical Manual of the respective hub at dtswiss.com.
SPLINE
- Technical Manual
®
Link
see instructions of the manufacturer
22