3. Slide the rotor (fig. 4-2/7) onto the hub while
performing a rotary motion.
4. Check if the rotor can be turned easily and if the
pawls lock.
5. Grease the bearings and the inner surface of
both end caps (fig. 4-2/1, 8).
6. Put on both end caps (fig. 4-2/1, 8) and push
them in by hand.
Caution: The shorter end cap must be attached on
the drive side.
Closing Steps
Mount the cassette.
Mount the brake disc.
Further information can be found in the Technical Manual of the respective hub at dtswiss.com.
SPLINE
- Technical Manual
®
Link
see instructions of the manufacturer
39