3. Position the «spoke tree» in the way that there is
no spoke crossing above the valve hole.
Check the positioning of the stickers on the
hub and on the rim.
Putting on the Nipple
If the wheel is equipped with the PHR system, consider
NOTICE
Risk of damage to the bladed spokes and the nipples!
• Bladed spokes must be hold with the spoke holder while turning the nipple.
• Different spokes types are used (see
• To avoid damages to the spoke, slide the spoke holder as far as possible in direction of the rim.
• To avoid damages to the nipples, slide the nipple wrench as far as possible onto the nipple.
1. Screw the nipple onto the spoke until the thread
disappears.
2. Repeat step on all spokes.
Caution: The figure shows a wheel with bladed
spokes.
chap. 5.4, page 44
chap. 6.1, page 64
SPLINE
- Technical Manual
®
for more information.
). Ensure that the correct tool is being used.
51