Converting The Control Elements; Converting From Remote To Manual Operation - DT SWISS O.D.L Technical Manual

6 Converting the Control Elements

:
DT Swiss forks are available with manual or remote control elements. The following chapters describe
the conversion between these versions and the installation of the remote levers.
• Conversion from remote to manual operation:
• Conversion from manual to remote operation:
• Installation of the lightweight remote lever:
• Installation of the Two In One remote lever:
6.1

Converting from Remote to Manual Operation

Preparatory Steps
Clean the fork.
Check all functions of the fork.
Required Material
thread lock
Removing the Remote Control Elements
1. Hold the compression wheel and unscrew the
fixing screw using a T8-Torx key.
2. Remove the compression wheel.
3. Unscrew the fixing nut of the remote wheel using
an 8 mm hex-key.
4. Remove the nut and the remote wheel.
chap. 6.1, page 34
chap. 6.2, page 38
chap. 6.3.1, page 42
chap. 6.3.2, page 43
Specification
Loctite 241 or Loctite 243
O.D.L - Technical Manual
Link
Amount
as required
34