5.6
Rebuild ing the Wheel [MTB]
Preparatory Steps
All spokes are available in the correct lengths.
Putting on the Spokes
General:
The crossing of the spokes must always be like
shown in the picture.
1. Slide all spokes through the spoke holes on the
first side of the hub.
For easier handling, first put the spokes into
the inner side of the hub.
2. Slide all spokes through the spoke holes on the
second side of the hub.
For easier handling, first put the spokes into
the inner side of the hub.
SPLINE
- Technical Manual
®
50