DT SWISS SPLINE ROAD 2017 RC 28 Mon Chasseral Technical Manual page 33

5. Put on both star ratchets (fig. 4-1/11) and the
second spring (fig. 4-1/10).
The small diameter of the spring must be placed
on the star ratchet.
Putting on the Rotor and the End Caps
1. Grease the rotor and put it onto the hub.
2. Check if the rotor can be turned easily and if the
star ratchets are locking.
3. Grease both bearings and the contact surface of
the end caps (fig. 4-1/1/13).
4. Put both end caps (fig. 4-1/1/13) onto the hub.
Note: The shorter end cap must be placed on the
drive side.
SPLINE - Technical Manual
®
32