DT SWISS SPLINE ROAD 2017 RC 28 Mon Chasseral Technical Manual page 49

Only for spokes in the inner spoke holes of the hub
flange.
5. Fully loosen the spoke (green) opposite the
spoke head of the spoke (red) that needs to be
replaced.
Caution: The figure shows a wheel with bladed
spokes.
Only for spokes in the inner spoke holes of the hub
flange.
6. Put the spoke (green) opposite the head of the
spoke (red) that needs to be replaced into the
middle of the spoke tree.
NOTICE
Risk of damaging the spokes and the hub!
Take care not to damage the paint of the spoke and the hub while removing the spoke.
Only for spokes in the inner spoke holes of the hub
flange.
7. Push the green spoke beside and slide out the
spoke that needs to be replaced (red).
SPLINE - Technical Manual
®
48