DT SWISS SPLINE ROAD 2017 RC 28 Mon Chasseral Technical Manual page 22

2. Put the axle (fig. 3-3/3) onto the mounting tool.
3. Put the non disc side of the hub shell onto the
tool and the axle.
4. Slightly grease the bearing (fig. 3-3/2) and put it
onto the disc side with the colored side facing
outwards.
5. Put the dismounting tool onto the axle.
6. Put the mounting tool onto the bearing.
The dismounting tool centers the mounting

tool on the axle.
7. Tap the bearing into the hub shell with slight
hammer strokes.
The lower mounting tool must lay on an even

surface.
8. Remove the tool from the hub.
SPLINE - Technical Manual
®
21