Connecting The "Spoke Tree" To The Rim - DT SWISS SPLINE ROAD 2017 RC 28 Mon Chasseral Technical Manual

5.8.3 Connecting the «Spoke Tree» to the Rim
1. Position the «spoke tree» in the way that there is
no spoke crossing above the valve hole.
Check the positioning of the stickers on the

hub and on the rim.
If the wheel is equipped with the PHR system, consider
2. Screw the nipple onto the spoke until the thread
disappears.
3. Repeat step on all spokes.
NOTICE
Risk of damaging the bladed spokes and the nipples!
• Bladed spokes must be hold with the spoke holder while turning the nipple.
• There are used different spokes types (see
used.
• To avoid damages to the spoke, slide the spoke holder as far as possible in direction of the rim.
• To avoid damages to the nipples, slide the nipple wrench as far as possible onto the nipple.
chap. 5.4, page 44
chap. 6.1, page 64
SPLINE - Technical Manual
®
for more information.
). Ensure that the correct tool is being
62