DT SWISS SPLINE ROAD 2017 RC 28 Mon Chasseral Technical Manual page 32

Putting on the Ratchet System
1. Clean the outer and the inner toothing of the star
ratchets using DT Swiss special grease.
For an optimal functionality, a thin layer of
grease is sufficient.
2. Grease the toothing of the rotor using DT Swiss
special grease.
3. Grease the bearing on the drive side using multi-
purpose grease.
Caution: There must not get grease onto the
toothing of the star nut.
4. Put on the spacer (fig. 4-1/9) and the first spring
(fig. 4-1/10).
The big diameter of the spring must be placed on
the bearing of the hub.
SPLINE - Technical Manual
®
31