Table of Contents
Advertisement
3.4
Converting the Hub [Inserted End Caps]
Preparatory Steps
Rear wheel: Remove the cassette if necessary.
Remove the brake disc.
Clean the hub.
Required Material
DT Swiss multipurpose grease
NOTICE
Risk of damaging the end caps!
To avoid damages, only use grind clamping jaws, aluminum clamping jaws or special tools to clamp the
end caps.
For simplification, the conversion of the hubs is only shown with a rear wheel QR hub. The following
actions are valid all axle version of front an rear wheel hubs with inserted end caps.
Removing the End Caps
1. Clamp the left end cap into a vise.
2. Pull the hub or the wheel upwards.
3. Clamp the right end cap into a vise.
4. Pull the hub or the wheel upwards.
Specification
CLASSIC Wheels - Technical Manual
HXTXXX00NMG20S
Link
see instructions of
the manufacturer
Amount
as required
14
Advertisement
Table of Contents
