Removing the Spoke to be Replaced
1. Put the wheel into the truing stand.
The following steps are based on a broken spoke. If the spoke is not broken, but damaged, it can
be cut with a wire cutter or something similar.
2. If necessary, cut the spoke:
a) Release the spoke using a screw clamp.
b) Cut the spoke.
c) Take off the screw clamp.
3. Check if there is a washer (PHR washer) on the
nipple.
4. Take the spoke with the nipple out of the rim.
If there is a PHR washer: Take care that the
washer does not fall into the rim profile.
SPLINE
- Technical Manual
®
47