Table of Contents
Advertisement
Battery master switch (if equipped)
ATTENTION: The battery master switch must be used
only for electrical repair and welding on the machine.
Located near the batteries, open the left-hand door.
When the key of the battery master switch is in "I" (On)
position, all electrical circuits are connected.
When the key of the battery master switch is in "O" (Off)
position, the electrical circuits are disconnected.
NOTICE: Never turn the key of the battery master switch
in "O" (Off) position when engine is running, the electrical
systems can be damage.
NOTICE: When the engine is stopped, always wait one
minute minimum before to place the key of the battery
master switch in "O" (Off) position, otherwise the com-
puter program of the hydraulic will not exit successfully.
NOTE: When the key of the battery master switch is in "O"
(Off) position, the stations stored on the radio presets and
the time set for the clock will be all cleared.
NOTE: The key can be remove from the battery master
switch.
3 - CONTROLS/INSTRUMENTS
3-71
1
05F4B0E3
2
408B33AD
Advertisement
Table of Contents
