Check The Measurement Result; View Your Previous Measurements; Switch Off The Tonometer And Dispose Of The Probe; Tonometer Modes - Icare HOME2 Instruction Manual

8.8

Check the measurement result

After a successful measurement, the measurement result is shown on the
display. The quality of the measurement is indicated with a color:
Green: good measurement quality
17
mmHg
Yellow: acceptable measurement quality
17
mmHg
The variation between the measurements was too high. Repeat the
measurement.
The tonometer stores the calculated eye pressure reading in mmHg, the
time and date of the measurement, which eye was measured and the
quality of the measurement.
The measurement quality is an indication of how much variation there was
between the six individual measurement results. The measurement quality
indication (green or yellow) is not related to the level of eye pressure
8.9

View your previous measurements

1. Press after you have seen the measurement result on the display.
2. Press until you see HISTORY
3. Press .
4. Press and to view your measurement results. The tonometer shows
the last 100 measurement results.
5. To exit the view, press
1
2
3
1–Date and time of the measurement
2–Measured eye
3–Measurement ordinal
4–Horizontal arrow indicates that you were standing or sitting during the
measurement, diagonal arrow indicates tilted position, and vertical arrow
indicates that you were lying down
5–Green result means good measurement quality, yellow means acceptable
quality.
24
on the display.
.
5
4
See chapter "12.3 Transfer measurement data to iCare CLINIC or iCare CLOUD"
for advice on how to transfer your measurement results to the iCare CLINIC
or the iCare CLOUD.
9 Switch off the tonometer and dispose of
the probe
To switch off the tonometer, press and hold down
and the display turns off. The tonometer turns off if you don't use it for three
minutes.
3
s
Remove the probe and put it back to the probe container.
Dispose of the probe and container in a mixed waste bin.
10

Tonometer modes

10.1

Practice mode

If you want to practice with the tonometer before taking a measurement,
use the practice mode. In the practice mode, you take 10 measurements,
and the display shows if a measurement was successful: the blue segments
on the circle are successful measurements and the red ones unsuccessful.
These measurement results are not stored on the tonometer's memory.
until you hear 3 beeps
25