Measure Your Eye Pressure - Icare HOME2 Instruction Manual

5. Keep both eyes open. Covering the eye not being tested may help
you see the rings more clearly.
6. Shorten the supports by rotating them clockwise two clicks at a
time until you only see a symmetrical green ring. The tonometer is
now at the correct distance from your eye.
START
8.5

Measure your eye pressure

1. Start the measurement when you see only a symmetrical green ring.
Press the Measure button
eye.
1x
START
2. A single beep indicates a successful measurement. Continue taking
measurements, until you hear a long beep and the light in the probe
base turns off.
20
5 mm
once. The probe gently touches your
3. If the probe base flashes red and you hear multiple beeps,
the measurement was not successful. The display and sounds
indicate the source of the error.
Look at the display and press
the necessary corrections and repeat the measurement. The errors
and corrective actions are explained in chapter "8.7 Errors during the
measurement".
4. A measurement sequence consists of six measurements.
6x
NOTE! You can also take the measurement sequence by pressing and holding the Measure
button down until all six measurements have been taken.
5. When all six measurements have been successfully taken, you hear
a longer beep. The light in the probe base turns off, and you see the
result on the display.
The measurement results are explained in chapter "8.8 Check the
measurement result".
NOTE! If you doubt the validity of a measurement result, for example, if you suspect
that the probe missed the center of your eye or contacted your eyelid, repeat the
measurement.
6. Press and repeat the measurement on your other eye, if needed.
to acknowledge the error. Make
21