Completing The Measurement - Icare HOME TA022 Patient Manual

14 Icare HOME Patient Guide
COMPLETING THE
MEASUREMENT
Press the Measure button
9
pressure (probe will contact eye during
measurements).
Press and hold the button (3 seconds) to collect 6
measurements in a row, or press the button briefly (1
second) 6 times to collect one measurement at a time.
i
PRECAUTION
If an error occurs (two short beeps and the probe
base light is flashing red), press the Measure but-
ton briefly (1 second) and continue measurement.
10
When the measurement ends successfully,
you will hear a long beep, the probe base
light will power off, and the Done light
illuminates.
After using the tonometer to measure your eye
pressure, you can remove the probe by powering
off the device and allowing the probe to slide
out of the probe base. Place the probe back in
its container and dispose of it in a normal trash
container or a metal waste bin.
WARNING
You should replace the probe if it comes into
contact with your eyelashes or eyelid or you
suspect it did.
11
If your doctor instructed you to measure both
eyes, repeat steps 1 through 10 using your
other eye. Use a new, unused probe after mea-
surements for both eyes have been taken.
After completing all measurements, power
12
off the tonometer by pressing and holding the
Power button
beeps.
i
PRECAUTION
The tonometer will power off automatically if
unused for 3 minutes.
ENGLISH
to measure
down until you hear 3 short
www.icare-usa.com 15