Vii.5 Rebooting The Receiver; Vii.6 Resetting The Receiver To Default - ScreenBeam 1100 Plus User Manual

VII.5 Rebooting the Receiver

To reboot your receiver, unplug the power adapter from the power outlet, wait 5 seconds and
then plug it in.
If you can't access the receiver locally, you can reboot the receiver through the receiver's
LMI.
To reboot the receiver with LMI, follow this procedure:
1. Log into the receiver's LMI and go to the Maintenance tab page.
2. Go to the Device Utilities section and click the Reboot button next to "Reboot Receiver".
3. Click OK on the pop-up message box to confirm.

VII.6 Resetting the Receiver to Default

To reset all settings of the receiver to default, follow this procedure:
1. Power on the receiver and wait until the "Wireless Display Ready to Connect" screen
appears.
2. Ensure that the Push Button feature is enabled. Refer to Section VII.3 Disabling the
Reset Button for details.
3. Press and hold the receiver's reset button.
4. When the "Resetting to factory defaults" screen appears on the HDTV, release the
reset button.
The receiver reboots, and it will be running with its default settings.
Note: This method will reset all settings to defaults.
If you can't access the receiver locally, you can reset the receiver through the receiver's LMI.
89