Iv.4.3 Supported Features; Iv.4.4 Setup And Instructions - ScreenBeam 1100 Plus User Manual

IV.4.3 Supported Features

Support USB HID display, projector, or whiteboard

Up to 20-point touch

Up to four simultaneous passive pens

 Up to two simultaneous active pens
Supported features may require compatible touchscreen and/or application. Works best with
InGlass™ Technology enabled display. Refer to the online compatibility list at:
https://support.screenbeam.com/touch/compatibility

IV.4.4 Setup and Instructions

Follow the steps below to set up and use the interactive touch feature:
1. Prepare the touch display and the USB touch cable supplied with the touch display.
2. Connect the USB Type-A end to the ScreenBeam 1100 Plus receiver's USB port.
3. Connect the USB Type-B/A end to the USB Touch input on the display or projector.
Note: If the display provides more than one touch output, make sure the USB Type-B/A
end is connected to the same touch output as the HDMI input.
4. Connect Windows 10 device to ScreenBeam 1100 Plus (see instructions in Part III
Connecting Client Device).
5. Ensure the "Allow ..." option is checked.
6. Start using the display by touching the screen. Launch an app and draw using finger or
pen.
36