Display Settings; Setting Up Display Sharing Mode - ScreenBeam 1100 Plus User Manual

7. Click the Apply button, and then click OK on the pop-up message box to confirm.
V.3.6

Display Settings

This section introduces display related features.
V.3.6.1 Setting up Display Sharing Mode
ScreenBeam 1100 Plus supports three display sharing modes: Single mode, Quick Switch
mode, and Multi-view mode.
To select a display sharing mode, follow this procedure:
Go to the Features tab page by clicking the Features tab.
1.
Go to the Display Setting section, and select a desired option from the Display Sharing
2.
Mode menu. Available options are: Single, Quick Switch, and Multi-View.
Single: Other device is not allowed to connect if the receiver is already in use.

Quick Switch: A Miracast capable device can connect to the receiver even though

the receiver is in an active Miracast connection.
Note: Quick Switch is available for Miracast connection only. Quick switch can't
work for Infracast connection (Wireless Display over LAN for Windows 10), Airplay
connection, or Chromecast connection.
Multi-View: This mode allows up to four sources connected to the receiver and

displayed on the TV at the same time.
Note: Multiview follows these rules below:
If PIN enforcement is enabled, Multiview is available to Miracast connections
•
only. In this case, when the first connection is an Infracast connection, Airplay
connection or Chromecast connection, no other connection is allowed.
If PIN enforcement is disabled, Multiview is available to Miracast connections
•
and Infracast connections. In this case, when the first connection is an Airplay
connection or Chromecast connection, no other connection is allowed.
58