Table of Contents
Advertisement
III.4 Connect using Existing Wireless Network or LAN
This section explains how to connect a client device to ScreenBeam 1100 Plus using existing
wireless network or LAN.
1.
Make sure that the Wireless display over LAN feature is enabled for Windows 10,
macOS/iOS AirPlay and/or Google Cast screen mirroring. Refer to section V.3.3 Wireless
Display over LAN for detail.
Note: You can also configure your receiver with CMS.
2.
Connect the ScreenBeam receiver to a known network where your client device can
communicate over Wi-Fi. Refer to Section II.2 Connecting the Receiver to a Network for
detail.
3.
Verify the receiver obtains an IP address (shown on the Wireless Display Ready to
Connect screen).
4.
Connect the client device to the same network as the ScreenBeam receiver.
24
Advertisement
Table of Contents
