Part Ii Installing The Receiver; Ii.1 Setting Up Screenbeam 1100 Plus Receiver - ScreenBeam 1100 Plus User Manual

Part II Installing the Receiver

This chapter explains how to connect ScreenBeam 1100 Plus to a display such as an HDTV
or projector. Make sure you have all the contents from the receiver's package available
before starting.

II.1 Setting up ScreenBeam 1100 Plus Receiver

It is quite easy and fast to set up the receiver. You can easily complete the setup by your own.
To connect ScreenBeam 1100 Plus to an HDTV:
1. Get the receiver, AC power adapter, and HDMI cable from the receiver's package, and
place the receiver next to the display.
2. Plug one end of the HDMI cable into the HDMI OUT port on the receiver, and the other
end into an available HDMI port on the display.
3. (Optional) If the display has USB HID touch capability, insert the HID USB connector
into a USB port on the ScreenBeam receiver. (USB cable is not included).
4. (Optional) Connect one end of the Ethernet cable to the receiver's Ethernet port and
connect the other end to the network switch with DHCP IP. (Ethernet cable is not
included).
Note: Refer to Section II.2 for more information on setting up a network connection.
5. Plug the connector of the power cord to the receiver's power input port labeled "12V/3A",
and plug the power adapter to a power outlet.
When the above steps are complete, the hardware should be connected as shown in
the figure below:
Note: Power adapter may vary in different region.
6. Turn on the display and set it to display the input from the correct HDMI port (the one
you have plugged into in Step 2).
7. Verify that the "Wireless Display Ready to Connect" screen appears on the display.
4