Network Settings; Setting Up Local Wi-Fi Network Mode - ScreenBeam 1100 Plus User Manual

Click the Apply button, and then click OK on the pop-up message box to confirm.
3.
V.3.8

Network Settings

This section introduces settings about network connection, such as local Wi-Fi networking
mode, CMS interface/Internet WAN interface assignment, connection and TCP/IP settings
for Ethernet/Wireless interface, etc.
V.3.8.1 Setting up Local Wi-Fi Network Mode
The receiver provides a local Wi-Fi network for wireless display over LAN and receiver
management. This network can be routed to an external network through the receiver's
Ethernet or wireless interface so that the device that connects to the local Wi-Fi can have
access to the Internet.
To set up the receiver's local Wi-Fi network mode, follow this procedure:
1. Go to the Network Settings tab page by clicking the Network Settings tab.
Go to the Local Wi-Fi Network section, and select an option from the Select Network
2.
Mode box. There are three options available: NAT, Bridge, and None.
NAT: The receiver's local Wi-Fi network is routed to the network where the Ethernet

or wireless interface connects by NAT method.
Bridge: The receiver's local Wi-Fi network is routed to the network where the

Ethernet or wireless interface connects by Bridge method.
None: The receiver's local Wi-Fi network is not routed to the network where the

Ethernet or wireless interface connects.
70