Table of Contents
Advertisement
If monitoring on an Ethernet interface, you may need an Ethernet hub (such as a NETGEAR®
EN 104) between the CO and the set-top-box, as shown in
Figure 20 IP video monitoring with a hub
To run IP video tests in Monitor mode
1
Verify that the network connection is established.
2
From the main Video menu, select a result menu.
– To view results for a specific stream, select Stream 3 Results (or the desired stream
number).
– To view total results for all streams, select Video Results.
3
Use the left or right arrow key to scroll through the screens.
4
To save a test report, press the utility (i) key and then select Save Report, and then specify
the report settings such as report name, report format, technician ID, location, and other
settings as needed.
5
To clear (or reset) the results, use the * key.
This will either Clear Stream if you are on a Stream Results menu or Clear Stats if you are on
the Total Video Results menu.
See
"Video results" on page 132
VideoCheck test
The VideoCheck test is an automated test used to verify the channels are provisioned as the
subscriber requested. See
June 2014
STB
Ethernet Hub
`
"Running the VideoCheck test" on page
SmartClass TPS User's Guide
22035456, Rev 001
Network
CO
to learn what your results mean.
Chapter 12 IP Video Testing
Figure 20
below.
34.
VideoCheck test
99
Advertisement
Table of Contents
Troubleshooting
