Receiving A Call; Answering Calls Automatically - JDS Uniphase SmartClass User Manual

Chapter 11 VoIP Testing
Placing and receiving calls
5 To transmit DTMF tones, select Touch-Tone Entry, and then use the keypad to specify the
tone to transmit. You should hear the tone.
If you are using the handset (internal speaker), press the key to talk.
6
This feature is only available on the VoIP Call menu and only when a call is active. It is not
available if you are transmitting (using IP voice announce or Tones as the transmit source,
selected on the Audio/Codec setup menu).
7 To view additional results, do one of the following:
– Press the right arrow three times.
– Press the Cancel key, and then select VoIP Results.
8 Optional. Use the Utility key to save the results to a file.
9 Use the # key to Hang Up.
The unit goes back on hook and ends the call.
10 Press the * key to clear the log.
See "VoIP results" on page 130

Receiving a call

The following procedure describes how to receive a VoIP call.
To receive a VoIP call
1 When the SmartClass Triple Play Services signals an incoming call, use the # key to Answer.
The unit goes off hook and answers the call.
After the call is connected, the results will update in the bottom area of the screen.
2 Optional. Press the * key to talk.
This feature is only available on the VoIP Call menu and only when a call is active.
3 To view additional results, do one of the following:
– Press the right arrow twice.
– Press the Cancel key, and then select VoIP Results.
4 To save a test report, press the utility (i) key and then select Save Report, and then specify
the report settings such as report name, report format, technician ID, location, and other
settings as needed.
5 Use the # key to Hang Up.
The unit goes back on hook and ends the call.
See "VoIP results" on page 130

Answering calls automatically

The Auto Answer feature allows you to verify incoming service as well as caller ID service. When
the SmartClass Triple Play Services answers a call, it logs the following information: time the call
was answered, caller's IP address, time the call ended.
The following procedure describes how to answer calls automatically.
90
to learn what your results mean.
to learn what your results mean.
SmartClass TPS User's Guide
22035456, Rev 001 June 2014